Looking for advice, just did the head gasket on my CT 200 H (same 2zr-fxe motor) and upon completion I have the codes P0016 and P0011. Marks are dead on as far as timing is concerned I replace the OCV solenoid as well. Head was resurfaced (removed .004“), and new valve seals were installed. I cleaned the EGR assembly and have new spark plugs. However, it is still misfiring bad at idle on cylinder three (occasional cyl 1,2 misfire at idle also) And rattles bad. Engine smoothes out around…
P0011, p0016, misfire after head gasket
